While we are reducing and lightening our Canmore footprint, the fabrication team at the Garcia shipyard has been working on the hull. Here are more pictures.
Firstly, the hull now has plates and the seams are welded shut. It also has a towing point at the stem.
Next, it also has portholes. This is how they start ... just tack welded in.
|And this is how they are finished.|
Mmmm, brushed aluminium.
This is how we expect the topsides (hull above the waterline) to be finished.
|Here, the worker is positioning the pivot into its cradle.|
|The very beefy pivot pin secured in place.|
|The interior of the hull, showing the solid welds to the ribs and stringers.|
|The portholes from the inside. The flange around the porthole is meant to receive the seven centimetres of insulating foam that the whole hull (above the waterline) gets.|
Check out the thickness of the aluminum, too!
|The hull is upside-down right now, so these standpipes come up (down?) through the bottom of the hull and go above the waterline. They draw water from outside the hull for use in cooling the diesel engine or for filtering into drinking water.|
|The aft (rear) skeg that protects the propeller shaft where it emerges from inside the hull. Worker standing next to the skeg (for scale).|
We have been told the welding of the hull will be done by the time we arrive in France in mid-May.